Fripa P 125 - Gasket Cutting Machine | F. u. J. Peters Aachen
Quick contact

Content

To Navigation

top

FRIPA P 125

Illustration P 125-300
Illustration P125-602


Download Datasheet FRIPA P 125 (pdf)

Gasket, ring and disk cutter

The machine is designed for cutting: rubber, asbestos and nonasbestos, leather, felt, cardboard, plastics and any other material suitable to be cut (e.g. graphite bonded with stainless steel).
The machine is designed for chipping:
Hard plastics and soft metals.

How to use the cutter

Machine type p 125 is available for fast cutting of gaskets, rings and plates made from the materials listed above. Machine types p 125/302 and P 125/602 permit inside and outside cutting to be performed in one pass.
For precise and rapid setting of the cutting tools, fixed rules are provided on the knife holder. The cutting tools can be adjusted in any direction. Only few turns will be required for executing a neat and clean cut. The machine is easy to operate and uncomplicated in handling. With the tools additionally offered, it is possible to cut all of the above mentioned materials without any problems.

For dimensions and weights please refer to the datasheet

[Illustrations and dimensions may be subject to changes as result of technical progress]

Download Datasheet FRIPA P 125 (pdf)

Accessories and spare parts


Cutting knife of tool steel (standard knife) [Ref.-No. 451]

for rubber and similar soft materials


Carbide cutting knife [Ref.-No. 452]

e.g. for fibrous materials, graphite bonded with stainless steel and all materials where long tool life is important


Cutting wheel with holder [Ref.-No. 453]

for all materials for which the rolling of the cutting wheel brings advantages, such as f. i. graphite, soft rubber types and similar materials, etc. (smallest cutting diameter is limited)


Cutting wheel without holder [Ref.-No. 454]

for all materials for which the rolling of the cutting wheel brings advantages, such as f. i. graphite, soft rubber types and similar materials, etc. (smallest cutting diameter is limited)


Chipping knife [Ref.-No. 455]

for stock removal e.g. on hard plastics, and other materials allowing a stock remo- ving operation


Hold-downplates [Ref.- No. 45-04]

for holding down the material to be cut. The softer and thinner the material, the more accurately the hold-down plate will have to be adapted to the cutting diameter.

(Comprising 4 pieces of Dia. 100-250mm)


Hold-downplates [Ref.- No. 45-10]

for holding down the material to be cut. The softer and thinner the material, the more accurately the hold-down plate will have to be adapted to the cutting diameter.

(Comprising 10 pieces of Dia. 100-250mm)